HP StorageWorks Core Switch 2/64 릴리스 노트 - 페이지 24

{카테고리_이름} HP StorageWorks Core Switch 2/64에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. HP StorageWorks Core Switch 2/64 24 페이지. Director power cord advisory instruction
HP StorageWorks Core Switch 2/64에 대해서도 마찬가지입니다: 빠른 사양 (13 페이지), 릴리스 노트 (27 페이지), 릴리스 노트 (20 페이지), 릴리스 노트 (13 페이지), 릴리스 노트 (11 페이지), 지침 (1 페이지)

페이지 인쇄

Known Issues

Erroneous Error Message When No Firmware File Selected

During a firmware upgrade, if the Download firmware file from field is left

blank, or erroneous text is entered in the field, the following error message

displays when you click Send and Load Firmware:

System File Error Firmware Successfully Loaded

Although the error message indicates that the firmware has been successfully

loaded, no changes were actually made to the switch or its firmware.

Workaround

Perform the firmware upgrade again, ensuring that the Download firmware from

file field contains a valid file name.

A Device Cannot Send Frames to Itself After the Active Zone Set Is

Deactivated

With the introduction of Hard Zoning in firmware 05.xx.xx, a device can no

longer send frames to itself after the active zone set (of which it is a member) is

deactivated.

Workaround

Perform a block/unblock to the port of the device experiencing this issue to cause

the device to log back in to the fabric and allow the device to send frames to itself.

False SBAR Failure in Director 2/64 Under Very High Fibre Channel

Traffic

In a Director 2/64, a false event 602 and 604 (active SBAR failure) may occur in a

very high traffic environment. The director fails over to the backup SBAR, and no

interruption of fabric operations is encountered.

Workaround

If an event 602 and 604 occur in a Director 2/64 and coincide with very high fibre

channel traffic, remove and replace the SBAR unit and verify the events do not

recur. If the events recur, then the SBAR is defective and must be replaced.

Director Release Notes