HP StorageWorks MSA 2/8 - SAN Switch 릴리스 노트 - 페이지 4
{카테고리_이름} HP StorageWorks MSA 2/8 - SAN Switch에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. HP StorageWorks MSA 2/8 - SAN Switch 10 페이지. Hp storageworks fabric os commands v3.1.x/4.1.x quick reference guide (aa-rte6b-te, june 2003)
HP StorageWorks MSA 2/8 - SAN Switch에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (9 페이지), 빠른 참조 매뉴얼 (8 페이지)
페이지 인쇄NOTE:
HP software release policy is to carry forward all fixes in patches to subsequent
maintenance and feature releases of Fabric OS.
Supported switches
Fabric OS v3.2.1 supports the following switches:
•
HP StorageWorks SAN Switch 2/8
•
HP StorageWorks MSA SAN switch 2/8
•
HP StorageWorks SAN Switch 2/16
Fabric OS 3.2.1 updates
Table 1
lists Fabric OS 3.2.1 fixes.
Table 1
Issues resolved in this 3.2.1 release
Issue prior to Fabric OS 3.2.1
Third party tape drives did not respond to
Login (L) bit, based on switch lock L port
configuration.
After executing switchdisable or enable
in a large, secure fabric, some SAN Switch
2/16 models experienced queue overflow
and rebooted.
No monitoring of basic monitor service
without an Advanced Performance
Monitoring (APM) license.
config upload failed on switches
supporting a large Zone database.
SAN Switch 2/16 models panicked when
connected to a third party switch during
Zoning updates in Interop mode.
SAN Switch 2/16 models used incorrect
buffer-tobuffer (BB) credits when switch BB
credit was set less than device BB credit.
4
Supported switches
Fix
Third party tape drives working with SAN Switch 2/16.
SAN Switch 2/16 in large, secure fabrics do not
experience queue overflow messages and switch reboot.
Basic monitoring allowed without an Advanced
Performance Monitoring (APM) license.
API_MAX_CONFIG size is increased.
SAN Switch 2/16 models operate normally during
Zoning updates in Interop mode.
Fabric OS 3.2.1 uses same BB credit limit as
defined in switch.