HP Xw460c - ProLiant - Blade Workstation 개요 - 페이지 32

{카테고리_이름} HP Xw460c - ProLiant - Blade Workstation에 대한 개요을 온라인으로 검색하거나 PDF를 다운로드하세요. HP Xw460c - ProLiant - Blade Workstation 35 페이지. Mezzanine card installation instructions for supported hp proliant c-class bladesystem servers
HP Xw460c - ProLiant - Blade Workstation에 대해서도 마찬가지입니다: 구현 매뉴얼 (35 페이지), 오류 방지 매뉴얼 (12 페이지), 기술 백서 (12 페이지), 펌웨어 업데이트 (9 페이지), 설치 매뉴얼 (2 페이지), 자주 묻는 질문 매뉴얼 (14 페이지), 설정 포스터 (9 페이지), 설치 매뉴얼 (33 페이지), 관리 매뉴얼 (28 페이지), 하드웨어 매뉴얼 (23 페이지), 사용자 설명서 (33 페이지), 최적화 매뉴얼 (13 페이지), 제한 보증 (10 페이지), 설치 지침 매뉴얼 (10 페이지), 설치 지침 매뉴얼 (8 페이지), 설치 지침 (4 페이지), 설치 지침 (2 페이지)

HP Xw460c - ProLiant - Blade Workstation 개요

Appendix: Fan and server population guidelines

For correct operation, fans and server blades must be installed in the correct bays of the HP
BladeSystem c7000 Enclosure. The BladeSystem Onboard Administrator ensures that fans and blades
are correctly placed before allowing systems to power on.

Fan bay numbering

Figure A-1 indicates the location of the ten fan bays in the back of the enclosure. Table A-1 identifies
the correct bays in which up to ten fans must be located.
Figure A-1. Required order for populating fans in the HP BladeSystem c7000 Enclosure
Table A-1. Fan bay population locations
Number of fans
Fan bays populated (cooling zones)
4
4, 5 (Zone 1) and 9, 10 (Zone 3)
6
3, 4, 5 (Zone 1) and 8, 9, 10 (Zone 3)
8
1, 2, 4, 5, 6, 7, 9, 10 (all four zones)
10
1, 2, 3, 4, 5, 6, 7, 8, 9, 10 (all four
zones)

Server blade bay numbering

Half-height server blades should be populated in the front of the enclosure from top to bottom and
from left to right. The first two half-height server blades should be placed in bays 1 and 9; the second
two half-height server blades should be placed in bays 2 and 10 and so on, until the enclosure is full.
Full-height server blades should be populated from left to right.
Device bays supported
Two devices located in bays 1, 2, 9 or 10
1–4, 9–12
1–4, 9–12, 5–8, 13–16
1–4, 9–12, 5–8, 13–16
32