Aquathem 10204-10 설치 매뉴얼 - 페이지 4

{카테고리_이름} Aquathem 10204-10에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquathem 10204-10 12 페이지. Swimming pool solar heating systems

Header Inserts (Part #50055-1 for

1 1/2"; #50055-2 for 2") are used

in special situations where

unusually high stagnation

temperatures are expected,

such as in a desert climate

or where abnormally high

system pressures may occur.

Use four (4) inserts per collector.

The Optional Supplemental High Wind Area

Collector Hold-Down Kit (Part #12035-1 for 1 1/2",

#12035-2 for 2") used in addition to the basic collector

installation kit in regions where high winds are prevalent.

Requires twice the amount of hold-down strap.

DISTANCE BETWEEN PANEL

HEADERS AND STRAPS

Collector

Panel Size

(A) Distance

(B) Distance

in feet

inches (cm)

_________

60 (152)

48 (122)

16 (40)

36 (91)

24 (60)

_____

MOUNTING THE SOLAR COLLECTORS

Refer to Figure 1 throughout this section. When mounting

the collectors, always make provisions for inlet connec-

tions at the bottom header and outlet connections at the

top. The outlet headers must be pitched a vertical dis-

tance of at least 8" (20cm) above the inlet headers to

assure proper drainage and uniform flow. Plan the col-

lector location to allow at least one foot on all sides of the

row of collectors for mounting brackets and piping. The

outlet pipe for each row of collectors must be connected

diagonally opposite the inlet pipe. Refer to Figure 2.

Figure 1

ASSEMBLY ON

ROOF DIAGRAM

Figure 2