Panasonic PT-L520E 사용 설명서 - 페이지 11

{카테고리_이름} Panasonic PT-L520E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-L520E 30 페이지. Lcd projector

페이지 인쇄

Inserting the batteries

# Open the cover.

$ Insert the batteries so that the

polarities are correct, and then close the

cover.

AAA batteries

(two)

NOTE:

B Do not drop the remote control unit.

B Keep the remote control unit away from liquids.

B Remove the batteries if not using the remote control unit for long periods.

B Do not use rechargeable batteries.

Operating range

If the remote control unit is held so

that it is facing directly in front of the

remote control signal receptors on

the front or rear of the projector, the

operating range is within

approximately 7 m (23´) from the

surfaces of the receptors.

Furthermore, the remote control unit

can be operated from an angle of

±30° to the left or right and ±15°

above or below the receptors.

20-E

NGLISH

NOTE:

B If there are any obstacles in between

the remote control unit and the

receivers, the remote control unit may

not operate correctly.

B If strong light is allowed to shine onto

the remote control signal receiver,

correct remote control operation may

not be possible. Place the projector as

far away from light sources as possible.

B If facing the remote control unit

toward the screen to operate the

projector, the operating range of the

remote control unit will be limited by

the amount of light reflection loss

caused by the characteristics of the

screen used.

Connections

Notes on connections

B Read the instruction manual for each system component carefully before

connecting it.

B Turn off the power supply for all components before making any

connections.

B If the cables necessary for connecting a component to the system are not

included with the component or available as an option, you may need to

fashion a cable to suit the component concerned.

B If there is a lot of jitter in the video signal which is input from the video

source, the picture on the screen may flicker. In such cases, it will be

necessary to connect a TBC (time base corrector).

B The projector has a built-in speaker. However, you will need to connect a

separate audio system to the AUDIO OUT jack if your needs specify high

sound volumes. No sound will come out of the projector's built-in speaker

while the AUDIO OUT jack is being used.

B It may not be possible to connect some types of computer. Refer to the list

of compatible signals on page 56.

B The pin layout and signal names for the S-VIDEO IN connector are shown

below.

Pin No.

External view

B The pin layout and signal names for the RGB/YP

connector are shown below.

Pin No.

(

External view

Pin + is spare.

Pins &–*, , and - are for earth.

Pins . and 1 functions are only valid when

supported by the computer

Signal

Earth (Luminance signal)

Earth (Colour signal)

Luminance signal

Colour signal

(RGB1 IN/RGB2 IN)

Signal

R/P

G/G·SYNC/Y

B/P

SDA

HD/SYNC

SCL

NGLISH

-21