Panasonic PT-L6510E 사용 설명서 - 페이지 42

{카테고리_이름} Panasonic PT-L6510E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-L6510E 50 페이지. 3600 ansi lumens sxga lcd projector 4200 ansi lumens xga lcd projector
Panasonic PT-L6510E에 대해서도 마찬가지입니다: 브로셔 및 사양 (6 페이지)

페이지 인쇄

Replacing the lamp unit

Caution!

Replacement of the lamp unit should

only be carried out by a qualified

technician.

Notes when replacing the lamp unit:

• The internal pressure of the light source is high, therefore if it is struck by hard objects or dropped, it may cause

damage. Be careful when handling.

• Handle the old lamp unit with care as it is easily broken.

• A Philips screwdriver is necessary when replacing the lamp unit. Be careful not to slip when using the screwdriver.

Caution

• The lamp unit is sold separately. Please consult the service/parts centre at your dealer.

Model No.

PT-L6510E

PT-L6600E

• Lamps other than those indicated above must not be used with this projector. Be sure to use the specified

lamp.

Lamp replacement period

The light source lamp of this projector has a life cycle of 2000 hours (Lamp power---hi, Lamp selection---dual

setting). However, this duration may be reduced depending on the usage of the projector-the frequency in which

the light is turned on and of its intervals affect the life of the lamp. Therefore it is recommended that a spare lamp

be made available before 2000 hours have elapsed. If the lamp unit is not replaced after 1800 hours, the power will

automatically shut off after 2000 hours and enter standby mode. If the power is turned on after 2000 hours, it will

turn off automatically after approximately 10 minutes and enter standby mode.

Note

• 2,000 hours is a guideline for replacement, not a guarantee time.

• Display after 1800 hours

The lamp monitor indicators (LAMP 1 or LAMP2)

will light after the lamp unit runtime has elapsed

1800 hours even during standby mode.

A n o n - s c r e e n m e s s a g e i n d i c a t i n g l a m p

replacement is necessary will be displayed on the

screen 30 seconds.

(This on-screen message will disappear after 30

seconds or the projector operation buttons remote

control buttons are operated.)

This on-screen message does not disappear,

unless a "MENU" buttons or sound adjustment

"(VOLUME +/-)" buttons will be pushed, if it

reaches in 2000 hours.

Lamp unit model No.

ET-LAL6510 (1 lamp) • ET-LAL6510W (2 lamps)

Caution!

Replace the lamp unit only after it has

completely cooled off.

REPLACE LAMP

S-VIDEO

AUTO