Panasonic PT-L6510E 사용 설명서 - 페이지 43

{카테고리_이름} Panasonic PT-L6510E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-L6510E 50 페이지. 3600 ansi lumens sxga lcd projector 4200 ansi lumens xga lcd projector
Panasonic PT-L6510E에 대해서도 마찬가지입니다: 브로셔 및 사양 (6 페이지)

페이지 인쇄

Lamp unit replacement steps

Caution

• After 2000 hours of operating the same lamp, it is only possible to operate the unit for approximately 10

minutes. Replace the lamp and steps 8 to 14 must be completed within 10 minutes:

1. Turn the power off by following the steps on page 23, remove the power plug and

confirm that the surroundings of the lamp unit have cooled off.

2. Using a Philips screwdriver, remove the

4 screws on the lamp unit cover located

on the rear of the projector.

3. Remove the lamp unit cover by pulling it

forward.

Caution

• Be careful not to break the tab located in the

centre of the lower side of the lamp unit cover.

4. Use a Phillips screwdriver to loosen the

two lamp unit fixing screws until the

screws turn freely. Then hold the handle

of the lamp unit and gently pull it out from

the projector.

Caution

The lamp unit will be hot after it has been

used.

You might get burned if you touch it while it is still hot.

5. Install the new lamp unit.

6.Use a Phillips screwdriver to securely tighten the 2 lamp unit fixing screws.

7. Install the lamp unit cover, and then use

a Phillips screwdriver to securely tighten

the lamp unit cover fixing 4 screws.

Caution

• Firmly install the lamp unit and lamp unit cover.

If not installed firmly, a protection circuit will

function and the power will not be turned on.

Fixing screws

Lamp unit cover

Tab

Lamp unit 1

Lamp unit 2

Handle

Lamp unit 1

Lamp unit 2

Fixing screws

PUSH

OPEN

Lamp unit cover

Tab