Panasonic PTL557U - LCD PROJECTOR 사용 설명서 - 페이지 23
{카테고리_이름} Panasonic PTL557U - LCD PROJECTOR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PTL557U - LCD PROJECTOR 48 페이지. Panasonic lcd projector operating instructions model no. pt-l557u
페이지 인쇄
Selecting the Image Quality
This LCD Projector can select NATURAL or DYNAMIC as the special characteristic of image quality.
Follow the instructions below to select the image qualities you prefer.
The procedure and on-screen displays below are based on RGB as the input signal.
1
Press MENU to display the menu.
2
Press
or
to select "RGB ADJUST", and
screen.
Note:
(1/2) or (2/2) displayed under "RGB ADJUST' indicates that the first or
second of two setting screens is displayed.
3
Press
or
to select "IMAGE QUALITY".
Note:
You can change the setting screen by pressing
the first item on the screen. or
the screen.
4
Press
o r
to select the image quality.
NATURAL is the factory S-VIDEO/VIDEO input signal setting.
DYNAMIC is the factory RGB or PC-CARD input signal setting.
Using the Auto Setup feature
When RGB input signal picture is projected from a PC (Personal Computer). It is possible to adjust the Vertical
position, Horizontal position, Horizontal size and Phase automatically. (This only applies for RGB input signal.)
Please follow the instructions below.
1
Input the signal of the full-screen projection image from the connected
device, and then project it.
2
Press
and
at the same time to start the Auto Setup feature.
AUTO SETUP screen is displayed.
AUTO SETUP screen disappears when Auto Setup feature is ended.
Note:
Adjusted settings are saved as is even if power is turned off.
Auto setup may not be possible if an image that is not clearly visible on
the end of the screen, or a dark image is input. In this case, refer to page
24 and adjust the image position, horizontal size, and phase.
If a signal other than the proper RGB input signal described on page 16 is
input, SIGNAL is displayed on-screen indicating that Auto Setup is not
possible.
o r
to display the
when the cursor is at
when the cursor is at the last item on
23