Diamondback 180 설치 매뉴얼 - 페이지 2

{카테고리_이름} Diamondback 180에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamondback 180 2 페이지. For toyota tacoma 2005; toyota tacoma 2006; toyota tacoma 2007; toyota tacoma 2008; toyota tacoma 2009; toyota tacoma 2010; toyota tacoma 2011; toyota tacoma 2012; toyota tacoma 2013; toyota tacoma 2014; toyota tacoma 2015; toyota tacoma 2016; toyota taco
Diamondback 180에 대해서도 마찬가지입니다: 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (2 페이지)

페이지 인쇄

ADJUST THE LOCK RODS

Use an 1/8" hex key to loosen the

set screws on the linkages of the

forward lock rods.

Adjust the length of the forward lock rods and retighten the set screws

so that:

A. with the lock handles in the open position, the rod tips clear the

square-tube top rail or deck rail system,

B. with the handle in the closed position, the rod tips do not strike

the bulkhead, and

C. the rods point downward.

ATTACH THE GAS SPRINGS

Attach the gas springs to the ball studs.

To avoid premature failure of your gas

springs, attach them barrel up, shaft down.

Leave the cover closed and locked for 24

hours to allow the weatherstrip adhesive,

which is pressure-sensitive, to fully cure.

WWW.DIAMONDBACKCOVERS.COM

1/8" Hex Key

With the lock handle in the

closed position, position the

lock rods tight against the

underside of the square-tube

top rail or the deck rail system

so that they'll draw

the panels down

and compress the

weatherstrip.

Tighten the rod guide

brackets with a 7/16"

socket.

Repeat steps 9–11 for the rearward lock rods so that:

A. with the lock handles in the open position, the rod tips clear

the T-panel gutter,

B. the rods point downward, and

C. closing them draws the panels down & compresses the

weatherstrip.

Double-check both panels to ensure they open, close, lock & seal

correctly. If at any point the weatherstrip does not touch the bed rails,

readjust the lock rods and mounting brackets as needed.

To ensure the best weatherstrip adhesion, leave your

cover and tailgate closed for 24 hours after you've

made your final adjustments.

Operating the access panels is easiest when

you press down as you open or close them.

7/16" socket

JANUARY 2016