Diamondback 64683 사용 설명서 및 안전 지침 - 페이지 9
{카테고리_이름} Diamondback 64683에 대한 사용 설명서 및 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamondback 64683 20 페이지. 7" heavy-duty tile saw with sliding table
페이지 인쇄
installing Splash Guards
1. Attach the Rear Splash Guard (40) to the back
of the Blade Guard with a Ø5 Flat Washer (11)
and M5 x 1 6 Pan Head Screw (14).
2. Align the hole on each end of the Side
Splash Guard (39) to the screw on each
side of the Blade Guard and press the holes
on the Splash Guard over the screws.
note: It is not necessary to loosen or
remove the screws on the Blade Guard
to install the Side Splash Guard.
installing the table
1. On the right side of the Table (61),
pull the Table Lock Lever (83) out.
Rotate the Toggle Table Stop
(118) to the unlock position.
2. Hold the Table parallel with the Water
Tray Frame (5), set the Table rollers
on the Frame rails and push the Table
toward the back of the saw.
3. Push the Table back along the Frame
rails until the final set of rollers
engage the rails. Rotate the Toggle
Table Stop to the lock position.
Item 64683
For technical questions, please call 1-888-866-5797.
Blade
Washer
Guard
rear
Splash
Guard
Blade
Guard
Side Splash
Guard
Splash Guard installation
table
Lock
unlock
Lever
Frame
rails
table
toggle
table
Stop
unlock
table installation
Ø 5
M5 x 1 6
Screw
Screw
Hole
Lock
toggle table
Stop
table Lock
Lever
Lock
Page 9