BIOMET SpinalPak 환자 설명서 - 페이지 7
{카테고리_이름} BIOMET SpinalPak에 대한 환자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BIOMET SpinalPak 12 페이지. Non-invasive spine fusion stimulator system
BIOMET SpinalPak에 대해서도 마찬가지입니다: 전체 설명서 및 패키지 삽입물 (10 페이지)
페이지 인쇄NOTE: Do not be concerned if the battery packs are inadvertently
charged more than once or kept on the charger cradle for a long
period of time. The battery pack cannot be overcharged. If the
battery pack is in the battery pack charger cradle and the battery
pack is fully charged, the charger will terminate the recharging
process. The charger cradle will indicate this termination when
the orange light does not illuminate. Additional replacement
battery packs are available by contacting Biomet.
LCD Symbol Descriptions and Instructions
The alarm defaults to audible alarm. Press the button below
the display on the front of the stimulator to silence the alarm.
The light will continue to flash and the display will indicate the
alarm condition.
Symbol
Condition
Treating
Audible alarm
engaged
Low battery
charge
Disconnection
of lead wire
System error
Device is
connected to
a pc
End of operation/ Contact Biomet
Treatment
Completion
Instructions
Continue use
If beeping, depress the button
briefly to silence the alarm.
D epress the button
approximately 3 seconds
to engage or disengage the
audible alarm
Insert a charged battery pack
Confirm that each electrode is
properly applied on the skin.
See the electrode pouch for
instructions. Confirm that
the lead wire is attached
properly. Replace the lead
wire if necessary.
E rror in the stimulator –
Contact Biomet for assistance.
Device will not treat until USB
cable is disconnected
6