BIOMET SpinalPak 환자 설명서 - 페이지 6

{카테고리_이름} BIOMET SpinalPak에 대한 환자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BIOMET SpinalPak 12 페이지. Non-invasive spine fusion stimulator system
BIOMET SpinalPak에 대해서도 마찬가지입니다: 전체 설명서 및 패키지 삽입물 (10 페이지)

페이지 인쇄

1. System Components

Warning: Do not attempt to charge any other battery pack.

Do not use the battery packs supplied with this unit in any other

device. Use of the Biomet

Stimulator System battery packs in any other device may cause

damage or malfunction to the battery pack and/or devices. Do not

short circuit, overcharge, crush, mutilate, nail penetrate, heat, reverse

the + or – terminals or disassemble the battery pack. Do not allow

metal objects to come into contact with the battery pack terminals.

These and any other abuses of the battery pack may cause serious

injury and/or burns. To ensure proper charging and safety, use only

the charger supplied with your device. Keep battery pack dry. This

battery pack must be disposed of properly. Disposal information

can be obtained by contacting the Rechargeable Battery Recycling

Corporation (RBRC) at 1-800-822-8837 in the US.

Step 4: Changing Battery Packs

Once daily, preferably at the same time every day to ensure treatment

is continued without interruption, patients should do the following:

A. D epress the battery door latch (1) and slide the battery door on

the back of the stimulator (2) and remove the depleted battery

pack (Figure 7).

B. Following the arrows, place

the depleted battery pack

into the battery charger cradle

for charging (Figure 8). A solid

orange light on the charger

cradle will illuminate indicating

a proper connection. If no

light appears on the charging

cradle an error is indicated.

If this occurs, try removing

the battery pack from the

charger cradle and reinserting

it. If the orange light does not

appear, contact Biomet.

C. O nce the charger cradle's

orange light turns off and a

solid green light appears, the

battery pack is fully charged.

Remove the battery pack

from the battery charger

cradle with a gentle lift (1, 2)

on the battery tab. (Figure 9)

and place the fully charged

battery pack into the Biomet

SpinalPak

Non-invasive Spine

Fusion Stimulator System in

order to commence treatment.

D. T here should always be one battery pack in the charger and one

battery pack installed in the stimulator at all times, ensuring a fully

charged battery pack every 24 hours as recommended.

SpinalPak

Non-invasive Spine Fusion

Figure 7

Figure 8

Figure 9