HTC 420 VS 사용자 설명서 - 페이지 24
{카테고리_이름} HTC 420 VS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HTC 420 VS 46 페이지. Floor grinder | concrete floor sander
HTC 420 VS에 대해서도 마찬가지입니다: 매뉴얼 (50 페이지)
페이지 인쇄Operation
Warning!
When changing tools or making repairs, the power to the machine
must be disconnected.
1.
2.
4.4. Fitting and replacing grinding tools
Warning!
When changing tools or making repairs, the power to the machine
must be disconnected.
Warning!
After grinding, the tools will be very hot. Tip the machine back
and allow it to stand for a short while. Use protective gloves when
removing the tools.
4.4.1. Fitting grinding tools
1.
Figure 4-2 Fitting grinding tools
2.
16
Set the handle to the rear position - see Figure
4-1 on page 15.
Tip the machine backwards so that it rests against the
ground.
Slide the grinding tool diagonally from above down into
the appropriate guide slot on the tool holder. Then push the
tool fully into the guide slot, see Figure 4-2 on page 16.
Lock the grinding tool into the tool holder by giving
it a few light taps with a rubber hammer, see Figure
4-3 on page 17.
HTC 420 VS
3.0