HTC 420 VS Посібник користувача - Сторінка 24

Переглянути онлайн або завантажити pdf Посібник користувача для Підлогова машина HTC 420 VS. HTC 420 VS 46 сторінок. Floor grinder | concrete floor sander
Також для HTC 420 VS: Посібник (50 сторінок)

Друкувати сторінку
Operation
Warning!
When changing tools or making repairs, the power to the machine
must be disconnected.
1.
2.

4.4. Fitting and replacing grinding tools

Warning!
When changing tools or making repairs, the power to the machine
must be disconnected.
Warning!
After grinding, the tools will be very hot. Tip the machine back
and allow it to stand for a short while. Use protective gloves when
removing the tools.

4.4.1. Fitting grinding tools

1.
Figure 4-2 Fitting grinding tools
2.
16
Set the handle to the rear position - see Figure
4-1 on page 15.
Tip the machine backwards so that it rests against the
ground.
Slide the grinding tool diagonally from above down into
the appropriate guide slot on the tool holder. Then push the
tool fully into the guide slot, see Figure 4-2 on page 16.
Lock the grinding tool into the tool holder by giving
it a few light taps with a rubber hammer, see Figure
4-3 on page 17.
HTC 420 VS
3.0