HTC 420 VS 사용자 설명서 - 페이지 40

{카테고리_이름} HTC 420 VS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HTC 420 VS 46 페이지. Floor grinder | concrete floor sander
HTC 420 VS에 대해서도 마찬가지입니다: 매뉴얼 (50 페이지)

페이지 인쇄
Electronic Error Codes
2.
3.
4.
Tip!
The machine will not start if the Grinding knob is in the "FWD"
mode when switching on the power.

7.3.2. Checking the last error code

For the buttons and knobs described here, see Figure
7-1 on page 32.
1.
2.
3.
4.
5.
6.
7.
32
Wait until the display switches off.
Reset the emergency stop switch.
Start the machine by turning the Power knob to "I".
Press Enter. rEF is shown in the display.
Turn the knob counter-clockwise, until non is shown in the
display.
Press Enter. rFr is shown in the display.
Turn the knob counter-clockwise, until nA1 is shown in the
display.
Press Enter. LIS1 is shown in the display.
Turn the knob counter-clockwise, until dP1 is shown in the
display.
Press Enter. The last error code is shown in the display.
Figure 7-1 Enter button and knob - Schneider
HTC 420 VS
3.0