EasyPro AquaShine RGB2-150 작동, 안전, 보증에 대한 지침 - 페이지 4

{카테고리_이름} EasyPro AquaShine RGB2-150에 대한 작동, 안전, 보증에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. EasyPro AquaShine RGB2-150 8 페이지.

페이지 인쇄

LED Light Kit Assembly Instructions for

1/2 to 1 hp Kasco VFX and JF Series Units

Actual light fixture appearance may vary slightly from figures below.

1. Attach the light fixture to the supplied brackets. The nylock nut

comes attached to the bracket for shipping. You will need to

remove nylock nut and install the yoke of the light fixture to the

bracket. Run the pig tail as shown in Figure 1. Secure the light

fixture with nylock nut. A three light set can be attached as you

see in Figure 2; the arrows indicate where you would attach a

two light kit (recommended only up to 3/4 hp units).

2. For Kasco units use the hardware pack labelled LKH-KBW

with shorter bolts and smaller washer. Put bolt through the

bottom of the bracket in the hole closest to the light.

Then line it up in holes on float and secure to float with washer

and nylock nut on top of float. Do not overtighten; simply make

sure it is snug and secure. Some movement of the bracket will

not affect quality of lighting. If you're attaching the lights to

another brand of fountain, you may need to purchase different

sized bolts.

3. Connect pigtails to cord splitter (two or three x 1 depending

on kit). To do this, be sure the pigtails go around the motor

screen in an orderly way so all lights can be connected without

twisting. When connecting cords, be sure the o-ring is present

in the female portion of the connectors. (Figure 3) Push pigtails

into splitter and secure with 1/2 turn quick connect nut on

splitter. (Figure 4)

4. Connect main cord to the remaining end of the splitter section.

Be sure the o-ring is present (Figure 3) and secure cords with

1/2 turn quick connect nut. (Figure 4) Multiple cords can be

connected up to 300' long between the light fixtures and the

control unit.

5. The main cord MUST BE SECURED to the float of the

fountain. Use the plastic cable ties included in your kit to do

this. This acts as a strain relief for the cords.

6. Adjust the angle of the light fixtures based on the spray pattern

being used. Tip in toward center for narrower pattern and tip

out slightly for wider pattern.

7. Plug the main cable into the pigtail of the mounted controller unit. Be sure to mount the

weatherproof controller with timer in a secure location near a power supply and plug into 115

volt outlet. See "Setting the Timer" for detailed instructions on the controller.

8. Over time the LED lights may appear dimmer than when new. This is caused by algae or

sediment on light lens. This can easily be removed with a small brush (a toothbrush works great).

Figure 1

Figure 2

o-ring

Figure 3

Figure 4