EasyPro AquaShine RGB2-150 작동, 안전, 보증에 대한 지침 - 페이지 5

{카테고리_이름} EasyPro AquaShine RGB2-150에 대한 작동, 안전, 보증에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. EasyPro AquaShine RGB2-150 8 페이지.

페이지 인쇄

LED Three Light Kit Assembly Instructions

for 2 hp Kasco VFX and JF Series Units

Actual light fixture may vary slightly from fixtures below.

1. For 2 hp Kasco units use the 3/4" pan head

screws from hardware pack labelled LKH-KBW

with nylock nut and smaller washer. Put screw

through the bottom of the bracket supplied with

the Kasco float. Then line it up in hole on light

bracket and secure with washer and nylock nut

as shown in Figure 1. Attach to brackets on 2 hp

Kasco in three locations seen in Figure 2. If you're

attaching the lights to another brand of fountain, you may

need to purchase different sized bolts.

2. Connect pigtails to three way cord splitter (three

x 1). To do this, be sure the pigtails go around the

motor screen in an orderly way so all lights can

be connected without twisting. When connecting

cords, be sure the o-ring is present in the female

portion of the connectors. (Figure 3) Push pigtails

into splitter and secure with 1/2 turn quick

connect nut on splitter. (Figure 4)

3. Connect main cord to the remaining end of the

splitter section. Be sure the o-ring is present

(Figure 3) and secure cords with 1/2 turn quick

connect nut (Figure 4). Multiple cords can be

connected up to 300' long between the light

fixtures and the control unit.

4. The main cord MUST BE SECURED to the float

of the fountain. Use plastic cable ties included in

your kit to do this. This acts as a strain relief for

the cords.

5. Adjust the angle of the light fixtures based on the

spray pattern being used. Tip in toward center

for narrower pattern and tip out slightly for wider

pattern.

6. Plug the main cable into the pigtail of the mounted

controller unit. Be sure to mount the weatherproof

controller with timer in a secure location near a

power supply and plug into 115 volt outlet.

See "Setting the Timer" for detailed instructions on the controller.

7. Over time the LED lights may appear dimmer than when new. This is caused

by algae or sediment on light lens. This can easily be removed with a small

brush (a toothbrush works great).

Figure 1

Figure 2

o-ring

Figure 3

Figure 4