Dickinson Newport - P9000 설치 및 운영 매뉴얼 - 페이지 6

{카테고리_이름} Dickinson Newport - P9000에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dickinson Newport - P9000 12 페이지. Propane fireplace/heater

DIRECT VENT STAINLESS STEEL FLEX PIPE

Four springs are installed between the inside and outside pipe to ensure that an even air space is

provided. IT IS IMPORTANT THAT TWO SPRINGS BE LOCATED AT ANY BEND IN

ORDER TO PREVENT THE PIPES FROM TOUCHING.

approximately 28" (70cm).

Bending the pipe will cause the pipe to stretch. The pipe can be cut with a fine hacksaw blade to

the required length.

unraveling and the diameter increasing.

The pipe is lubricated during the manufacture process. This lubricant will burn off on the first

firing of the heater.

Additional 28" (70cm) lengths of pipe are sold as an option ( Part No. 19-000). This pipe can be

cut with a fine hacksaw blade to the required length. A coupling fitting is provided with the

optional length.

DIRECT VENT THRU-FITTING AND CAP

Deck Flange

Screw Pilot Holes

Deck

4 Mounting Screws

INSTALLATION PROCEDURE

Step - 1 Cut a 3" hole through the deck, ceiling or wall.

Step - 2

www.ahoycaptain.com

The pipe can be stretched to provide several additional inches.

Tape the end of the pipe while cutting to prevent the pipe from

Make sure the sealing gasket is installed under the above deck-flange before

screwing down the fitting.

the boat, so that it is not visible.

secure with the 6 S/S screws supplied.

6" (15cm)

3" (75mm)

Flexible Double Pipe

Rotate the fitting to position the pipe seam, inside

Holding the deck flange firmly in position

The length of pipe supplied is

6 Mounting Screws

Sealing Gasket

Dress Ring