Dickson HT300 빠른 시작 매뉴얼

{카테고리_이름} Dickson HT300에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dickson HT300 2 페이지. Bottle logger

페이지 인쇄

Warranty

Dickson warrants this line of instruments will be free from defects in material and

workmanship under normal use and service for a period of twelve months, after delivery.

This warranty does not cover routine calibration or battery replacement. For

Specifications and Technical Support, go to

or contact us via telephone at 800.323.2448.

Factory Service and Returns

Contact Customer Service 630.543.3747 for a Return Authorization Number (RA) before

returning any instrument. Please have the model number, serial number and PO ready

before calling.

V4 06282016

http://www.dicksondata.com

DICKSON

DICKSON Bottle Logger

DICKSON

Bottle Logger

Bottle Logger HT300

Getting Started

Presets

Sample Rate = 1 Minute

•

Stop or Wrap When Full = Wrap

•

DicksonWare

Unit of Measure =

•

Quick Start

Install DicksonWare

Version 17.23 or higher

•

Install Battery

Each end of the HT300 can be removed. The battery is located on the cap end

•

with the lanyard hole. Note the battery symbol etched on this end of the case.

Remove the cap carefully by twisting the cap counter clockwise.

•

Insert the battery positive side in first.

•

Replace the battery cap tightly.

•

It may take up to 5 seconds for the unit to power on.

•

Open DicksonWare

software via the icon on your desktop.

•

NOTE: It is very important to attach the correct cap to the correct end of the

case. The cap end with the lanyard hole and spring must always go on the

battery end of the case.

Setup Logger

The USB port is located opposite end of the case. Note the USB symbol etched

•

on the USB access end of the case.

Remove the cap.

•

The USB port is just inside the logger opening.

•

Connect the USB cable to the logger and to an available working USB port on

•

your PC.

Your computer should detect the logger when it is powered on and connected to

•

the computer via the USB connection. Depending on your version of Windows,

the computer may go through an Add New Hardware routine. Click on the Setup

button. You will be prompted to select USB or Serial COM Port Connection.

Select USB then Click Continue. A Setup window will appear. All fields should be

automatically filled in, confirming that DicksonWare

logger. Should all fields remain blank, refer to the troubleshooting section in

this manual

Once DicksonWare

recognizes the logger, press the Clear button. This will

•

delete all data currently stored.

The logger is now ready to be placed in the desired logger location.

•

Software

(All of these features can be modified by click on the main Setup button.)

Setup (button)

Click this button first to establish communications between the logger and

DicksonWare

software. You may be prompted to select the communication

method between USB or Serial COM port. You may save this setting so you will

not be prompted again. This setting is also changeable in

File/Preferences/Communications. A Setup window will appear with "all fields"

populated. This confirms that the software has recognized the logger. Should

the fields remain blank then communication has not been established, refer to

the Troubleshooting section of this manual

HT300

has recognized your