Alpha Group OutBack Power EnergyCell 200PLC 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Alpha Group OutBack Power EnergyCell 200PLC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alpha Group OutBack Power EnergyCell 200PLC 20 페이지.

Installation and Operation

DC Wiring

Terminal Hardware

EnergyCell PLC battery terminals consist of a threaded stud which receives a

hardware is assembled as shown in Figure 6.

NOTE : Install the cable lugs (or interconnects) and all other hardware in the order illustrated.

The lug or interconnect should be the first item installed. It should make solid contact with the

mounting surface. Do not install hardware in a different order than shown.

NOTE : To avoid corrosion, use plated lugs on cable terminations. When multiple cables are

terminated, use plated terminal bus bars.

Tighten the terminals to a torque value of 97.4 to 130.1 in-lb (11 to 14.7 Nm).

Cleaning Battery Terminals

To minimize contact resistance, it is important that the lead terminals of the batteries be cleaned

of any oxidation that may have occurred during transportation and storage. It is most

convenient to clean them prior to placing them on the rack.

Lightly brush the terminal contact surface areas with a brass bristle brush or the equivalent.

Next apply a light coating of special antioxidant grease such as NO-OX-ID or NCP-2 to the

surfaces. This will protect the lead terminal from further oxidation.

CAUTION: Equipment Damage

Never reverse the polarity of the battery cables. Always ensure correct polarity.

CAUTION: Fire Hazard

Always install a circuit breaker or overcurrent device on the DC positive conductor

for each device connected to the batteries.

CAUTION: Fire Hazard

Never install extra washers or hardware between the mounting surface and the

battery cable lug or interconnect. The decreased surface area can build up heat.

M6 Nut

Flat

Washer

Battery

Terminal

Stud

Figure 6

Terminal Assemblies

nut.

Lock

Washer

Cable Lug or

Interconnect

Battery

Terminal

Surface

Terminal

900-0227-01-00 Rev A