Dictator DICTAMAT 50 WS-MFL 기술 매뉴얼 - 페이지 13

{카테고리_이름} Dictator DICTAMAT 50 WS-MFL에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dictator DICTAMAT 50 WS-MFL 17 페이지.

6) Tensioning the

Wire Rope and the

Supporting Rope

Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail [email protected] • 201906

C) Installation of the DICTAMAT 50 WS-MFL - cont.

5b) Fixing the Kevlar rope of the spring rope pulley on the

door leaf

The Kevlar rope has to run straight from the spring rope pulley, i.e. exactly

horizontally and in-line, without any lateral deviation.

IMPORTANT: When choosing the fixing point for the rope of

the spring rope pulley, you have to make sure that the travel of

the spring rope pulley allows the complete travel of the door!

Usually the pressed on eyelet of the Kevlar rope of the spring rope pulley

is fixed by means of the quick chain link (marked red in ill. 30) to the

oblong hole in the bracket with the radial damper.

When fixing the rope you have to make sure

the rope runs absolutely straight. If necessary,

you can remove the safety pin - but only when

the rope has been securely fastened. The safety

pin shall prevent the rope from uncoiling when

accidentally being released during mounting.

Before starting the adjusting work, the wire rope as well as the supporting

rope are finally tensioned. For the proceeding see points C/3e and 3f).

Don't tension the wire rope too much, as otherwise moving the

door will require too much effort. The correct tension is achieved

when the rope doesn't rest or touch anywhere.

After having completed the adjusting work according to the following

pages, you should operate the door about ten times and then again

control the tension of the ropes.

Technical Manual

DICTAMAT 50 WS-MFL

IMPORTANT:

Page D50WS-MFLHB.013

. 30

Ill

. 31

Ill