Alpha Moisture Systems DS5000 사용 설명서 - 페이지 4

{카테고리_이름} Alpha Moisture Systems DS5000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alpha Moisture Systems DS5000 19 페이지. Dewpoint monitor

1 General Information

• The DS5000 Monitor is a DIN style panel mounted moisture monitoring device

designed to work in conjunction with the DT45 Dewpoint Transmitters.

• The readout of moisture content is displayed on a backlit, 4 digits, seven segment

LCD, in any one of six selectable engineering units (see DS5000 specification). The

selected unit is displayed on a separate seven segment LED.

• The user has the option of displaying pressure corrected or uncorrected moisture

values.

• The instrument can be operated from either an AC or DC power source (see DS5000

specification for details).

• The DS5000 operation is controlled by a four-button membrane keypad. The user-

friendly software uses a simple menu selection process and incorporates several hot

keys to read the transmitter temperature and the two alarm trigger points.

• Two fully customer controllable access security levels.

• The Model DS5000 utilises the advanced DT45 Dewpoint Transmitter, which allows

complete interchange ability of transmitters.

• The calibration data is stored within the transmitter and is readable from the DS5000

display.

• The DS5000 can perform auto-calibration and implement offsets on the attached

transmitter. All the values are stored on the transmitter retaining the interchangeability

of the transmitters.

• The DS5000 has two full range alarms that can be set as rising or falling edge

triggered. These alarms are visual (LED), audible and activate changeover relays for

remote indication or control.

• The DS5000 also has two independently, variable span, fully controllable linear

outputs. 1) 4-20mA and 2) 0 to 5V. The voltage output can be factory set to 0-100mV

or 0-1V.

• Details of normal operation, engineering unit selection, transmitter data and

configuration of the instrument are described within this manual.

Read the safety information below, before installation.

Hazardous voltages may be present on instrument terminals. The equipment must be installed

by suitably qualified personnel and the instrument must be mounted in a position that

provides protection, behind the panel, to at least IP20.

The power supply terminals and associated internal circuitry are isolated from all other parts

of the equipment in accordance with EN61010-1 for connection to a category II supply

(pollution degree2).

1188 Instruction Man DS5000.doc

Page 1 of 16