Alpha Moisture Systems DS5000 사용 설명서 - 페이지 5
{카테고리_이름} Alpha Moisture Systems DS5000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alpha Moisture Systems DS5000 19 페이지. Dewpoint monitor
페이지 인쇄
Any terminals or wiring connected to the input or output, which are accessible in normal
operation, must only be connected to signals complying with the requirements for Safety
Extra Low voltage (SELV) circuits.
The mains supply to the instrument must be protected by an external 1-amp fuse and a
suitable switch or circuit breaker, which should be near the instrument.
Note: The instrument contains no user serviceable parts.
3 Installation
3.1 Installing the Instrument into a Panel
Make a cut-out in the donor panel 138.0 x 68.0mm (DIN 43700).
The maximum panel thickness is 8mm and, if an effective IP65 weatherproof seal is required,
the minimum recommended panel thickness is 1.6mm.
Pass the instrument case through the cut-out in the donor panel and attach the two retaining
screws to the studs on either side of the case.
Tighten the retaining screws onto the back of the donor panel until the instrument is clamped
securely in position. The screws must be tightened sufficiently to affect a seal between the
front of the donor panel and the back of the instrument bezel, but never over tightened.
3.2 Instrument Wiring
Wire the DS5000 as per figure 1.1 below.
YELLOW
GREEN
SENSOR
BLUE
CONNECTIONS
RED
1188 Instruction Man DS5000.doc
0-5V
-
Output
+
4-20mA
-
Output
+
A B C D + -
Figure 1.1
Alarm 1
Alarm 2
N
NC N
NC
O
O
+ -
+ - N GND L
NO
C NC NO
C NC
+ve
Power Supply
90-250V AC
GN
50/60 Hz
D -ve
Max Power
10VA
-ve
Power Supply
+ve
12V DC
Max Power
10VA
Page 2 of 16