Epever TRACER 6420 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Epever TRACER 6420에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epever TRACER 6420 8 페이지.

TRACER 6420 Frequency Conversion Document

6. Carefully flex the cables to swap the connections. Be careful with the RF cables, making sure that the

minimum bend radius of the cable is greater than 0.75"; bends and loops smaller than a quarter will

cause the RF cable to break. Use the wiring guidelines in Figure 2 for help with wire placement.Click

here

for a digital picture of this step.

Allowing the RF cables to sit on the processor and radio boards (green) could cause

damage to the boards; keep the RF cables off the boards while re-routing them. Click

for a digital picture of this mistake.

CH 2

7. Use the torque wrench to reconnect the RF cables to the Chan connectors. Tighten the cables by

turning clockwise until you hear a click from the wrench. DO NOT overtighten connectors as this will

cause the RF cable to break. The TRACER 6420 system will not operate properly with broken RF

cables.

8. Reinstall the cover and carefully tighten all screws.

9. Change label on back of the unit to reflect the Plan change.

612806420L1-18A

CH 1

PLAN A

Figure 2. TRACER 6420 Cable Routing Diagrams

CH 2

CH 1

PLAN B

here