DieHard 200.713121 소유자 매뉴얼 - 페이지 5
{카테고리_이름} DieHard 200.713121에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.713121 16 페이지. 12/2/75 amp fully automatic battery charger engine starter
DieHard 200.713121에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)
페이지 인쇄It
is impodant to understand
your charger's requirements.
This section will tell you
about your charger's
electrical
requirements
and how to prepare a battery for
charging.
ASSEMBLING
YOUR CHARGER
Included with your battery charger are
two cord wrap posts for storage of the
clamp cables.
To install, align the three tabs to
correspond
with the three receptacles
and push until you hear a snap.
Wrap clamp cord after unplugging
the
power cord and store your charger in a
dry location.
[_
(--Cord Wrap Cleat
PLUGGING
IT IN
WARNING:
Electrical Shock Hazard.
Be sure that the power cord fits properly
into the outlet. If not, have a qualified
technician
install a proper outlet. Never
alter the AC cord or plug provided.
Improper connection can result in
electrical shock.
Your charger requires a 120V receptacle
installed according to all local codes and
ordinances.
USING AN EXTENSION
CORD
The use of an extension cord is not
recommended.
If you must use an
extension cord, please make sure
that you follow these guidelines:
•
Make sure that the pins on charger's
power cord fit firmly into the extension
cord, and that the extension cord fits
firmly into the receptacle.
•
Check that the extension cord is
properly wired and in good electrical
condition.
Make sure that the wire size is large
enough for its length and for the AC
ampere rating as specified in the chart
below.
Length of Cord, In Feet
25
50 100
150
AWG* Size of Cord
18
16
12
10
*AWG=American Wire Gauge
5