EPHESUS Arena 650 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} EPHESUS Arena 650에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EPHESUS Arena 650 16 페이지. All field led luminaire

Installation Instructions - All Field LED Luminaire

Power Quality

The lighting circuits shall have surge protection. If you require assistance in checking your power system or designing or

implementing solutions, contact Eaton's Electrical Engineering Services and Systems. Find more information at www.eaton.

com.

INSTALLATION INSTRUCTIONS

Step 1 – Mount The Luminaire

The first step is to attach the luminaire to the mounting structure. The mounting structure may be a light pole cross arm, an

indoor catwalk bracket, or other structural component that will hold the fixture in place. Refer to photometric drawings or

project Installation Drawings for luminaire installation locations and any additional mounting instructions.

It is the responsibility of the installer to verify that all proposed mounting structures including poles, cross arms,

catwalk brackets, and other mounting structures are certified to support the weight of the luminaires, withstand

wind loads, and meet all other applicable codes and regulations. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO

DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.

Do not suspend any luminaire by electrical or control wires, as these will not support the weight of the fixture,

resulting in the potential for the fixture to fall and cause damage or injury. FAILURE TO FOLLOW THIS WARNING MAY

LEAD TO DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.

Equipment Required:

Mounting Hardware

●

Socket wrenches and/or crescent wrenches sized to fit mounting hardware

●

Cable ties or wire management – For outdoor installations use UV rated

●

Hardware Required

Mounting Hardware Required

Mounting hardware shall be stainless steel or other high-strength, corrosion-resistant material. Length of Hex bolt shall be

determined in the field; size the bolt appropriately to allow secure fastening of the luminaire to the mounting structure.

An impact driver may be used on mounting hardware while the power is off, but NEVER use any power tools on the

fixture while the power is on. The vibration caused by power tools may damage the fixture. FAILURE TO FOLLOW

THIS WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE AND FAILURE.

There are two different ways to mount the All Field fixture – Standard and Inverted. Standard mounting is when the luminaire

sits on top of the mounting structure, and Inverted is when the luminaire hangs from underneath the structure.

EATON

MN507001EN

Hex bolt

5/8"-3/4" (16mm-19mm)

Flat washers

5/8"-3/4" (16mm-19mm) ID

Hex Locknut

5/8"-3/4" (16mm-19mm)

Installation instructions rev 170117

WARNING

Size

Quantity per luminaire

WARNING