EPHESUS Arena 650 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} EPHESUS Arena 650에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EPHESUS Arena 650 16 페이지. All field led luminaire

Standard Mounting

This is the most common mounting. The luminaire sits on top of mounting structure.

Refer to the project Installation Drawings to determine luminaire installation locations and lens type.

For each fixture location, install a luminaire that has the correct lens type. Unless otherwise noted, fixtures that share

the same lens type are identical.

Set luminaire in place and install bolt, flat washers, and nut to securely fasten the fixture mounting bracket to the

mounting structure. Tighten hardware hand tight so that fixture is secure but do not fully torque hardware until aiming is

complete.

Remove the clear protective film from the front of the lenses, if present.

Example mounting structure shown for illustration purposes only.

otee:

Figure 2. Standard Mounting

Inverted Mounting

The luminaire hangs from underneath mounting structure.

When using inverted mounting, flip the mounting bracket so that the luminaire stays upright. NEVER install the

luminaire upside down. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE AND

FAILURE.

To install the luminaire underneath a mounting structure, the fixture mounting bracket must first be inverted

Remove Hex bolt and set screw on each side of the fixture.

●

Remove Fixture Mounting bracket and flip it so that the bracket faces up.

●

Reinstall hex bolts and set screws on each side of the fixture.

●

Refer to the project Installation Drawings to determine luminaire installation locations.

For each fixture location, install a luminaire that has the correct lens type. Unless otherwise noted, fixtures that share

the same lens type are identical.

Hold luminaire in place and install bolt, flat washers, and nut to securely fasten the fixture mounting bracket to the

mounting structure. Tighten hardware hand tight so that fixture is secure but do not fully torque hardware until aiming is

complete.

Remove the clear protective film from the front of the lenses, if present.

Hex Bolt

Washers

Locknut

Installation Instructions - All Field LED Luminaire

Mounting

Structure

WARNING

EATON

MN507001EN

All Field Installation Manual rev 20170324