DieHard DieHard 200.71990 운영자 매뉴얼 - 페이지 6

{카테고리_이름} DieHard DieHard 200.71990에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard DieHard 200.71990 8 페이지. Jump starter/dc power source
DieHard DieHard 200.71990에 대해서도 마찬가지입니다: 운영자 매뉴얼 (8 페이지)

페이지 인쇄

TO ORDER AND REPLACE JAwS

Part Number

2299001580

5.1

Battery Clamp Jaw Replacement

•

Secure clamp in open position using a vise or equivalent clamping

device. IMPORTANT: Make sure the rotary switch on the front panel is in

the O (OFF) position and the jump starter is not plugged into a 110V AC

electrical wall outlet.

•

Unscrew fastener securing the cables to the rear of the top jaw.

•

Unscrew fasteners (2) securing the Copper Jaws to the plastic clamp.

Remove the jaws and braided cable.

•

Reverse for assembly.

STORAgE AND MAINTENANCE

IMPORTANT:

•

CHARgE IMMEDIATELY AfTER PURCHASE

•

KEEP fULLY CHARgED.

Charge the internal battery immediately upon purchase, every 30 days

and after every use.

All batteries are affected by temperature. The ideal storage temperature is

at 70 degrees Fahrenheit. The internal battery will gradually self-discharge

(lose power) over time, especially in warm environments. Leaving the

battery in a discharged state may result in permanent battery damage. To

ensure satisfactory performance and avoid permanent damage, charge

the internal battery every month.

When the jump starter is ON, the clamps are live and will produce arcing

or sparking if they come in contact with each other. To prevent accidental

arcing, always keep the clamps on the storage holders and the JUMP

START ON/OFF switch in the OFF position when not using it to jump start

a vehicle.

Description

Kit, Battery Clamp Rebuild

•

QTY Per Clamp