DieHard Portable Power 1150 운영자 매뉴얼 - 페이지 6

{카테고리_이름} DieHard Portable Power 1150에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard Portable Power 1150 15 페이지. Diehard portable power 1150 battery charger operator's manual
DieHard Portable Power 1150에 대해서도 마찬가지입니다: 소유자 매뉴얼 (11 페이지), 운영자 매뉴얼 (16 페이지), 운영자 매뉴얼 (12 페이지), 운영자 매뉴얼 (17 페이지)

페이지 인쇄

Use in a well-ventilated

area. Keep hands, hair, clothing and jewelry clear

of fan blades, belts, pulleys and other parts that may cause injury.

4.1

Turn ignition off before making cable connections.

4.2

Place the 1150 on a flat, stable surface near the vehicle battery and away

from moving engine parts.

4.3

Connect the red clamp to the positive (+) terminal d the vehicle battery.

4.4

4.5

4.6

NOTE: In the rare case of jump-starting

a vehicle that has a positive-

grounded vehicle electrical system, connect the black clamp to the

negative terminal of the vehicle battery. Then connect the red clamp to

an unpainted and unmoving part of the vehicle chassis or engine block. If

you are unsure of the nature of the vehicle's electrical grounding system,

check the owner's manual of the vehicle or call the Customer Technical

Assistance number: 1-800-SEARS-64.

Connect the black clamp to an unpainted and unmoving part of the vehicle

chassis or engine block. Do not connect to the carburetor, fuel lines or

sheet-metal body parts. The Digital Display displays the vehicle's voltage.

CAUTION:

If you have connected the clamps backwards, an audio alarm

will sound. DO NOT turn the ON/OFF switch to the ON position. This could

cause serious damage. Reverse the connections and the audio alarm wilt

stop.

Turn ON the JUMP START ON/OFF switch and then turn key and crank

the engine. If the engine does not start within 5-8 seconds, stop cranking

and wait at least one minute before attempting to start the vehicle again.

This permits the battery to cool down.

After the engine starts, make sure to turn OFF the Jump Start switch.

Then disconnect the black clamp (-) and then the red clamp (+) in that

order.

4.7

Recharge the 1150 as soon as possible after use.

CAUTION: To prevent sparking while the 1150 jump-start switch is in the

ON position, NEVER allow the clamps to touch together or to contact the

same piece of metal. Never attempt to charge a frozen battery.

.4.