Acculaim Dyna Drum HO 사용자 설명서 - 페이지 8
{카테고리_이름} Acculaim Dyna Drum HO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acculaim Dyna Drum HO 20 페이지.
페이지 인쇄Power and control wiring
The power and control cords (roughly five feet, 1.5m in length) enter the casing via water-
tight glands at the rear of the fixture. As standard the cords are supplied as bare tails.
Power
The power requirements are as follows:
• Voltage:
100-277VAC 50/60Hz
• Power:
228W at steady state
The power cord color designations are as follows:
Power cord colors
US version
In-rush current
Although LED fixtures are low power devices compared to their incandescent equivalents,
their power supplies exhibit a trait known as 'in-rush current' when they are first powered
on. This is caused by the various components within the switching power supplies topping
themselves up with power. The in-rush current period lasts only milliseconds and does not
cause any effect when a handful of units are powered on at the exact same time. However,
if many fixtures are linked to the same power input, they will momentarily pull a current that
may greatly exceed their normal operating level. This may affect over-current trips when
power is applied. For this reason it is advisable to limit the number of fixtures on any one
power input.
6
Power cord colors
European version