Olympus DP72 사용 설명서 - 페이지 4

{카테고리_이름} Olympus DP72에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus DP72 40 페이지. Microscope digital camera

IMPORTANT

The DP72 microscope digital camera is designed to be connected to a camera adapter mounted on an

Olympus UIS2/UIS series of optical microscope (not applicable to the LB series) for use in recording of

microscopic magnified images at high speed (about 2.5 seconds) and highest resolution while maintaining

high picture quality and high color reproduction. The DP72 incorporates a variety of functions for supporting

image recording under optimum conditions.

When the DP72 microscope digital camera is used with a camera adapter or a microscope from other

manufacturer than Olympus, the optical performance may not be manifested fully.

SAFETY PRECAUTIONS

CAUTION

Never connect or disconnect the interface cable while the standby switch

Otherwise, malfunction may result.

1. Before connecting or disconnecting the interface cable, make sure that the standby switch

OFF.

When connecting the interface cable, push in the connector all the way and ensure that the connector will not slip out

before setting the standby switch

Do not move the computer or apply an impact to it while it is powered ON.

2. The cords and interface cables are vulnerable to bend or twist. Do not apply excessive force to them.

3. To prevent the microscope from toppling down, avoid using microscope attachments that may make the total height of

the microscope above 1 meter when they are attached.

4. When installing the PCIe interface board, be sure to hold it by the edge. Never touch the board surface directly, as this will

lead to malfunction.

The area (IC) of the PCIe interface board very hot during

and immediately after use of the camera. Be careful never

to touch them during and after use.

5. For handling of the computer, refer to the separately provided

"Computer User's Manual."

6. Connect the power cord correctly and ensure that the grounding

terminal of the power supply and wall outlet are properly

connected. If the equipment is not grounded/earthed, Olympus

can no longer warrant the electrical safety performance of the

equipment.

7. Lay out the interface cable so that it does not contact the heat-

generating section such as the lamp housing of the microscope.

to ON.

of the computer is set to ON.

of the computer is set to

Hot part