Olympus EVOLT E-300 빠른 매뉴얼 - 페이지 4

{카테고리_이름} Olympus EVOLT E-300에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus EVOLT E-300 5 페이지. Evolt e-300 manuel de base (français)
Olympus EVOLT E-300에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 브로셔 및 사양 (10 페이지), 기본 매뉴얼 (34 페이지), 사양 (3 페이지), (스페인어) 기본 설명서 (34 페이지), (프랑스어) 마누엘 드 베이스 (34 페이지)

페이지 인쇄

Programming of Dandelion for Olympus and Panasonic

Before you start

Prepare your camera as described as in part I

Programming of Dandelion is simple and includes three steps:

1. Activation of the program mode

2. Command input

3. Data input

Activate program mode in Dandelion. In order to do that press the lens reset button and no later

than in 2.5 seconds press and hold the preview button for 10 seconds. At the 11th second the

camera will display aperture sign "-.-". This means that Dandelion has entered the program mode.

Press the lens reset button again. Dandelion will be ready to accept the command and data. Control

dial will let you change the aperture from F4.0 to F11. Herewith each aperture corresponds to a

number (see table 1).

Aperture

Corresp. number

All new Dandelions by default have a 10-second delay before activation. You can change it from 01

to 99 seconds (see F11 function). A short delay helps activate the program mode quicker. A longer

delay excludes the possibility of an accidental activation.

Make sure that you press the preview button no later than 2.5 seconds after you pressed the lens

reset button, and that you hold it continually for 10 seconds. Otherwise the program mode will not

be activated. The camera has to be prepared as described as in part I; if not, there is no guarantee

that all commands will work correctly.

Dandelion will stay in the program mode until you enter command and data. If you wish to quit the

program mode anyway, turn the camera off using Power on/off switch.

Command and Data Input

Command input is as simple as pressing the preview button on a certain aperture. After that you will

have to enter several digits (data). The data are to be entered as such, for example, the number 28

must be entered in the following way: first 2, then 8.

List of Commands And Their Formats

F4.0 + 2 digits - aperture change. The first digit corresponds to an aperture value before point.

The second digit - to an aperture value after the point. For example, to set aperture 2.8 press the

preview button successively on apertures F4.0 (command – F5.6 works with older adapters), F5.0

(the first digit is 2), F10 (the second digit is 8).

Aperture change ranges from F1.0 to F9.9. If the command and two digits are entered correctly,

there will appear aperture sign "-.-" on the display. Press the lens reset button and check the result.

Mind that if aperture is set from F1.0 to F1.9, it will influence exposure metering and reduce it.

F4.0

F4.5

F5.0

Table 1. Apertures and corresponding numbers.

F5.6

F6.3

F7.1

F8.0

F9.0

F10

F11