Olympus EVOLT E-300 빠른 매뉴얼 - 페이지 5

{카테고리_이름} Olympus EVOLT E-300에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus EVOLT E-300 5 페이지. Evolt e-300 manuel de base (français)
Olympus EVOLT E-300에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 브로셔 및 사양 (10 페이지), 기본 매뉴얼 (34 페이지), 사양 (3 페이지), (스페인어) 기본 설명서 (34 페이지), (프랑스어) 마누엘 드 베이스 (34 페이지)

F5.6 + 5 digits - focal length change. The digits are to be entered from greatest to least. If the

focal length is less than 5 digits, add zeros. For example for 50mm: 00050. All five digits have to be

entered.

Therefore to change focal length to 50mm, press the preview button successively on the following

apertures: F5.6 (command), F4.0 (the first digit is 0), F4.0 (the second digit is 0), F4.0 (the third

digit is 0), F7.1 (the forth digit is 5), F4.0 (the fifth digit is 0).

Focal length ranges from 00001mm to 65535mm. If the command and five digits are entered

correctly, an aperture sign "-.-" will appear on the display. Press lens reset button and check the

result.

F8.0 + 2 digits from 01 to 17 - correction of focus confirmation dot - or Dandelion

calibration function. You may move the dot a bit forward or backward, to manually find the

calibration constant. By default Dandelion is set for the center, constant 09

F11 + 2 digits - delay before entering the program mode. This is set to 10 seconds by default.

You can change it into 01 to 99 seconds.

Mind that if the delay timing is set to 60 to 99 seconds, you will have to hold the preview button

continuously for more than 1 minute to enter the program mode. The camera may enter the sleep

mode during this time, so make sure that the sleep mode is activated no earlier than after 2 minutes

in your camera.