Olympus BH2 Series 분해, 청소 및 재조립 - 페이지 40
{카테고리_이름} Olympus BH2 Series에 대한 분해, 청소 및 재조립을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BH2 Series 45 페이지. Phase contrast
Olympus BH2 Series에 대해서도 마찬가지입니다: 문제 해결 및 조정 매뉴얼 (46 페이지), 완전한 분해, 청소 및 재조립 (23 페이지), 완전한 분해, 청소 및 재조립 (40 페이지), 매뉴얼 (6 페이지), 설치 매뉴얼 (9 페이지)
페이지 인쇄
Figure 172 – Blow all loose dust from the mirror surface
Next, place the frame of the Light Exit Assembly into a
suitable container to catch cleaning solution and rinse
water (see
Figure
173).
Figure 173 – Place the frame into a suitable catch pan
Apply a suitable optical cleaning solution (item 4 of
Appendix
1) over the entire reflective surface of the
mirror (see
Figure
174). Allow the cleaning solution to
soften the debris on the mirror surface for a while
before proceeding with the cleaning.
Figure 174 – Wet the reflective surface of the mirror
Use a soft-bristled brush (item 10 of
carefully clean the wetted reflective surface of the
Teardown, Cleaning, and Reassembly of the Miscellaneous Parts of the Olympus BH-2 Microscope Frames
Appendix
1) to
mirror by gently wiping the surface with the soft-
bristled brush (see
Figure
Figure 175 – Carefully clean the primary surface mirror
After the mirror has been gently cleaned in this manner,
thoroughly rinse away the cleaning solution and
loosened dust with lots of distilled or deionized water,
so as to not leave water spots when the mirror dries
(see
Figure
176).
Figure 176 – Rinse the mirror with distilled/deionized water
Use a lens duster bulb (item 11 of
away as much of the rinse water as possible (see
177). Allow the complete frame to thoroughly air-dry in
a dust-free location before proceeding.
attempt to dry the mirror surface with any sort of wipe
or tissue or the fragile reflective surface will be
permanently damaged.
Figure 177 – Blow away most of the rinse water
175).
Appendix
1) to blow
DO NOT
Revision 1
Page 40 of 45
Figure