Olympus BH2 Series Демонтаж, очищення та повторний монтаж - Сторінка 40
Переглянути онлайн або завантажити pdf Демонтаж, очищення та повторний монтаж для Мікроскоп Olympus BH2 Series. Olympus BH2 Series 45 сторінок. Phase contrast
Також для Olympus BH2 Series: Посібник з усунення несправностей та налаштування (46 сторінок), Повний демонтаж, очищення та повторний монтаж (23 сторінок), Повний демонтаж, очищення та повторний монтаж (40 сторінок), Посібник (6 сторінок), Посібник з монтажу (9 сторінок)
Figure 172 – Blow all loose dust from the mirror surface
Next, place the frame of the Light Exit Assembly into a
suitable container to catch cleaning solution and rinse
water (see
Figure
173).
Figure 173 – Place the frame into a suitable catch pan
Apply a suitable optical cleaning solution (item 4 of
Appendix
1) over the entire reflective surface of the
mirror (see
Figure
174). Allow the cleaning solution to
soften the debris on the mirror surface for a while
before proceeding with the cleaning.
Figure 174 – Wet the reflective surface of the mirror
Use a soft-bristled brush (item 10 of
carefully clean the wetted reflective surface of the
Teardown, Cleaning, and Reassembly of the Miscellaneous Parts of the Olympus BH-2 Microscope Frames
Appendix
1) to
mirror by gently wiping the surface with the soft-
bristled brush (see
Figure
Figure 175 – Carefully clean the primary surface mirror
After the mirror has been gently cleaned in this manner,
thoroughly rinse away the cleaning solution and
loosened dust with lots of distilled or deionized water,
so as to not leave water spots when the mirror dries
(see
Figure
176).
Figure 176 – Rinse the mirror with distilled/deionized water
Use a lens duster bulb (item 11 of
away as much of the rinse water as possible (see
177). Allow the complete frame to thoroughly air-dry in
a dust-free location before proceeding.
attempt to dry the mirror surface with any sort of wipe
or tissue or the fragile reflective surface will be
permanently damaged.
Figure 177 – Blow away most of the rinse water
175).
Appendix
1) to blow
DO NOT
Revision 1
Page 40 of 45
Figure