Olympus BH2-5RE 완전한 분해, 청소 및 재조립 - 페이지 14

{카테고리_이름} Olympus BH2-5RE에 대한 완전한 분해, 청소 및 재조립을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BH2-5RE 18 페이지. Modular revolving nosepiece

Apply Grease to the Mechanical Detents

Apply fresh grease (item S2 of

mechanical detent notches in the revolving turret (see

Figure

37).

Be careful that you do not get grease

anywhere else.

Figure 37 – Apply grease to the five detent notches

Place the protective cover into position on the back side

of the turret assembly, lining up the three holes in the

protective cover with the three tapped holes in the

stationary base (see

Figure

Figure 38 – Place cover in position on the turret assembly

Use a suitable JIS screwdriver to reinstall three M2X3

countersink screws to secure the protective cover onto

the stationary base (see

Complete Teardown, Cleaning, and Reassembly of the Olympus BH2-5RE Modular Revolving Nosepiece

Appendix

1) to the five

38).

Figure

39).

Figure 39 – Secure protective cover using three screws

Place the dovetail slide into position on the back side of

the turret assembly, lining up the four holes in the

dovetail slide with the four corresponding tapped holes

in the stationary base (see

the dovetail slide such that the relief notch (see inset of

Figure

40) is facing downwards and towards the slotted

lock ring on the pivot-adjustment screw.

Figure 40 – Position dovetail slide onto stationary base

Use a suitable JIS screwdriver to reinstall four M2.6X5

pan-head screws to secure the dovetail slide onto the

stationary base of the turret assembly (see

Figure 41 – Secure dovetail slide onto stationary base

Figure

40). Be sure to orient

Figure

41).

Page 14 of 18

Revision 3