Olympus BH2-5RE Volledige demontage, reiniging en hermontage - Pagina 14
Blader online of download pdf Volledige demontage, reiniging en hermontage voor {categorie_naam} Olympus BH2-5RE. Olympus BH2-5RE 18 pagina's. Modular revolving nosepiece
Pagina afdrukken
Apply Grease to the Mechanical Detents
Apply fresh grease (item S2 of
mechanical detent notches in the revolving turret (see
Figure
37).
Be careful that you do not get grease
anywhere else.
Figure 37 – Apply grease to the five detent notches
Reinstall the Protective Cover
Place the protective cover into position on the back side
of the turret assembly, lining up the three holes in the
protective cover with the three tapped holes in the
stationary base (see
Figure
Figure 38 – Place cover in position on the turret assembly
Use a suitable JIS screwdriver to reinstall three M2X3
countersink screws to secure the protective cover onto
the stationary base (see
Complete Teardown, Cleaning, and Reassembly of the Olympus BH2-5RE Modular Revolving Nosepiece
Appendix
1) to the five
38).
Figure
39).
Figure 39 – Secure protective cover using three screws
Reinstall the Dovetail Slide
Place the dovetail slide into position on the back side of
the turret assembly, lining up the four holes in the
dovetail slide with the four corresponding tapped holes
in the stationary base (see
the dovetail slide such that the relief notch (see inset of
Figure
40) is facing downwards and towards the slotted
lock ring on the pivot-adjustment screw.
Figure 40 – Position dovetail slide onto stationary base
Use a suitable JIS screwdriver to reinstall four M2.6X5
pan-head screws to secure the dovetail slide onto the
stationary base of the turret assembly (see
Figure 41 – Secure dovetail slide onto stationary base
Figure
40). Be sure to orient
Figure
41).
Page 14 of 18
Revision 3