Olympus BH2-CH Substage 어셈블리 - 페이지 20

{카테고리_이름} Olympus BH2-CH Substage에 대한 어셈블리을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BH2-CH Substage 26 페이지.

Figure 76 – Remove the bearing ball from the pinion gear

Grasp the pinion gear protruding from the right-hand

side of the main housing and withdraw the pinion shaft

(see

Figure

77).

Figure 77 – Withdraw the pinion shaft from main housing

Remove the metal flat washer from the pinion shaft

(see

Figure

78).

Figure 78 – Remove metal washer from the pinion shaft

Remove the small nylon washer from the recess in the

inner ledge of the main housing (see

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

Figure

79).

Figure 79 – Remove nylon washer from the main housing

Reinstall the Condenser-Height Shaft

Using a suitable solvent (e.g., acetone), clean any old

grease from the pinion shaft, the tension screw, the

bearing ball, the metal flat washer, and from the nylon

washer. The various components of the condenser-

height shaft are shown in

Figure 80 – Components of the condenser-height shaft

Use a cotton swab and a suitable solvent (e.g., acetone)

to clean the grease from the bore in the left-hand side

of the main housing (see

in the inner ledge of the main housing where the nylon

washer seats.

Figure 81 – Clean grease from bore in the main housing

Figure

80.

Figure

81) and from the recess

Revision 1

Page 20 of 26