Olympus BH2-CH Substage Montaj - Sayfa 20
Mikroskop Olympus BH2-CH Substage için çevrimiçi göz atın veya pdf Montaj indirin. Olympus BH2-CH Substage 26 sayfaları.
![Olympus BH2-CH Substage Montaj](/uploads/products/server2/4281661/4281661.png)
Figure 76 – Remove the bearing ball from the pinion gear
Grasp the pinion gear protruding from the right-hand
side of the main housing and withdraw the pinion shaft
(see
Figure
77).
Figure 77 – Withdraw the pinion shaft from main housing
Remove the metal flat washer from the pinion shaft
(see
Figure
78).
Figure 78 – Remove metal washer from the pinion shaft
Remove the small nylon washer from the recess in the
inner ledge of the main housing (see
Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly
Figure
79).
Figure 79 – Remove nylon washer from the main housing
Reinstall the Condenser-Height Shaft
Using a suitable solvent (e.g., acetone), clean any old
grease from the pinion shaft, the tension screw, the
bearing ball, the metal flat washer, and from the nylon
washer. The various components of the condenser-
height shaft are shown in
Figure 80 – Components of the condenser-height shaft
Use a cotton swab and a suitable solvent (e.g., acetone)
to clean the grease from the bore in the left-hand side
of the main housing (see
in the inner ledge of the main housing where the nylon
washer seats.
Figure 81 – Clean grease from bore in the main housing
Figure
80.
Figure
81) and from the recess
Revision 1
Page 20 of 26