Olympus BX2 SERIES 유지 관리 매뉴얼 - 페이지 18
{카테고리_이름} Olympus BX2 SERIES에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BX2 SERIES 29 페이지. Olympus microscope bx2
Olympus BX2 SERIES에 대해서도 마찬가지입니다: 정보 (6 페이지)
페이지 인쇄
BX2 MAINTENANCE MANUAL
2-2 Confirmation of X-wire tension
*1
2-3 Confirmation of Y-wire tension
F
Note: If the wire is too tight, image backlash may occur.
If the tension is below the standard value, slip may occur between the knob
and the wire deteriorating the image movement.
REPAIR PROCEDURE
A
C
D
B
B
A
*1
1) Move the X-guide "A" to the center of
the upper stage "B" , press"C" of the
X-wire using the fan-shaped tension
gauge(OT3232). If the tension does not
meet the standard, adjust the tension
so as to be within the standard when
the X-wire comes into contact with "D"
wall by means of the CSK3X5SA(*1)
screw.
Tension standard
1) Press the upper part of Y-wire "A" indicated
by the the arrow with the fan-shaped
tension gauge. If the tension does not meet
the standard, adjust the CSK3X5SA(*1)
scew so that the tension is within the
standard when the Y-wire comes into
contact with "F" part of the lower stage "B"
when seen from the above.
Tension standard
- 15 -
0.25-0.3N(25-30gf)
0.88-0.98N(90-100gf)