Olympus BX2 SERIES 유지 관리 매뉴얼 - 페이지 9

{카테고리_이름} Olympus BX2 SERIES에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BX2 SERIES 29 페이지. Olympus microscope bx2
Olympus BX2 SERIES에 대해서도 마찬가지입니다: 정보 (6 페이지)

페이지 인쇄

BX2 MAINTENANCE MANUAL

3. Preparing for inspection

ADJUSTMENT OF KOEHLER ILLUMINATION

1) Set the main switch "A" to "I" (ON) and adjust the brightness by turning the adjustment knob "B" .

2) Set the light path selector knob "C" to the pushed-in position.

(Pushed-in position: Binocular 100%, Middle position: Binocular 20% Photo/TV 80%, Pulled-out position: Photo/TV 100%)

3) Place a specimen on the stage.

4) Engage the 10X objective in the light path.

5) Turn the condenser height adjustment knob "D" to raise the condenser to its upper limit.

( When using the U-SC3 swing-out condenser, move the top lens into the light path.)

6) Looking through the eyepiece in the right sleeve without the diopter adjustment ring, turn the

coarse and fine focus adjustment knobs to bring the specimen into focus.

7) Looking through the eyepiece in the left sleeve with the diopter adjustment ring, turn only the

diopter adjustment ring "E" to focus on the specimen.

(At this time, adjust the interpupillary distance so that the binocular visions on the left and

right fields of view coincide completely.)

8) Turn the field iris diaphragm ring "F" in the direction of the arrow so that the iris diaphragm image

comes inside the field of view.

9) Manipulate the condenser height adjustment knob "D" to focus on the iris diaphragm image. (See Fig.1)

10) Turn the two condenser centering screws "G" to move the iris diaphragm image to the center

of field of view. (See Fig. 2)

11) Gradually open the field iris diaphragm. The condenser is properly centered if the iris diaphragm

image is centered and inscribed in the field of view. (See Fig.3)

(During actual use, open the field iris diaphragm slightly until its image circumscribes the field

of view. See Fig.4)

Reference: Since the contrast of microscope specimens is ordinary low, setting the condenser

aperture iris diaphragm to between 70% and 80% of the N.A. of the objective in use

is usually recommended. If necessary, adjust the ratio by removing the eyepiece

and looking into the eyepiece sleeve while adjusting the aperture iris diaphragm ring "H".

MAINTENANCE PROCEDURE

OL YMPUS

Field iris

BX51

diaphragm image

1 2

1 1

1 0

PRE-SET

Fig.2

Fig.1

- 6 -

Fig.3

Fig.4