Olympus BX3-SSU 사용 설명서 - 페이지 14

{카테고리_이름} Olympus BX3-SSU에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BX3-SSU 24 페이지. Scanning stage with ultrasonic
Olympus BX3-SSU에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)

페이지 인쇄

Under certain conditions, performance of the scanning stage with ultrasonic may be adversely affected by factors other than

defects. If problems occur, please review the following list and take remedial action as needed.

If you cannot solve the problem after checking the entire list, please contact your local Olympus representative for assistance.

1. Stage

a) The stage cannot be moved by

rotating the X-/Y-axis knobs.

b) The coarse/fine adjustment cannot

be switched by pressing the coarse/

fine selector button.

c) The stage cannot be moved smoothly

when a high-power objective is

used.

d) The stage movement has become

unsmooth after a long period of

use.

e) The auto compensation of the stage

fails.

f ) The stage movement range became

narrow.

2. Stage control box

a) The pilot lamp does not light.

Downloaded from

ManualsNet.com

TROUBLESHOOTING GUIDE

Problem

Connection cable is disconnected.

The stage is moved until the stopper at

the end of stroke.

The error mode is entered because the

stage was moved quickly by hand.

Connection cable is disconnected.

The operating environmental tempera-

ture has changed drastically.

Fine particles produced due to wear

of the stage's sliding surfaces are

deposited.

The cable of the stage is stretched.

The auto compensation is not comple-

ted within the specified time.

The stage origin position is misreco-

gnized.

The main switch of the control box is

not ON.

Power cord is connected improperly.

Fuse in control box is blown.

Cables are connected improperly.

search engine

Cause

Connect the cable.

Use the area near the center of the

stage.

Turn power off then on again.

Connect the cable.

Perform the auto compensation in

"System Setting" of the touch-panel

controller.

Set the control box to "

move the stage manually into all of the

front, rear, left and right directions (full

strokes). And then, perform the Auto

Compensation of the stage

Loosen the cable and perform the auto

compensation again.

Turn ON the power of each unit again

and perform the auto compensation

again. If you may fail in the auto com-

pensation for several times, contact the

Olympus sales office where you have

purchased the device.

Compensate the stage.

Set the main switch to " I " (ON).

Connect the power cord properly.

Replace the fuse with a new one.

Connect the cables properly.

Remedy

Page

" (OFF) and