Olympus BX43 사용 설명서 - 페이지 40

{카테고리_이름} Olympus BX43에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BX43 48 페이지. System microscope

Fig. 49

Fig. 50

Fig. 51

Use only coded 5 position nosepiece for BX43 (BX43-5RES)

} Distribute its cable | toward the rear panel by passing it below the arm,

and connect the cable to the connector no the rear panel.

} As shown in Fig. 49, connect to the connector by letting the cable into

the cable holder (attached with BX43-5RES) attached to the rear panel.

Attaching the Condenser

1. Turn the coarse adjustment knob @ to raise the stage to its upper limit.

2. Turn the condenser height adjustment knob 2 to lower the condenser

holder to its lowest position.

3. Fully loosen the condenser clamping knob 3.

4. Position the condenser so that the aperture scale is located in front.

Gently slide the condenser along the dovetail all the way until it is

stopped.

} When attaching the U-SC3 swing-out condenser, align the positioning pin

at the back of the condenser with the groove in the condenser sleeve.

· When attaching a swing-out condenser with a positioning pin at

CAUTION

the back such as the U-SC3, attach by aligning the positioning

pin with the groove in the condenser sleeve.

· When attaching a condenser with swing-out top lens, swing out

the top lens out of the way before inserting the condenser.

5. Tighten the condenser clamping knob and gently raise the condenser

holder to its highest position.

Attaching the Eyepieces

Gently insert the eyepieces all the way into the eyepiece sleeves.

· When using the U-BI30-2 binocular tube, eyepieces with a po-

CAUTION

sitioning pin cannot be attached because the U-BI30-2 does

not have the positioning notch.

· When using an eyepiece with micrometer, attach it to the right-

hand eyepiece sleeve.

When doing so, make sure that the eyepiece positioning pin @

fits into the notch 2 on the eyepiece sleeve.

· The super-widefield trinocular observation tube is equipped with

a positioning notch on both the left and right eyepiece sleeves.

Make sure that the positioning pins on both eyepieces fits into

the respective notches.

(Fig. 50)

(Fig. 51)