Olympus CK40 사용 설명서 - 페이지 13

{카테고리_이름} Olympus CK40에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus CK40 39 페이지. Culture microscope

Fig. 15

†

Fig. 16

Connecting the Lamp Cord Plug and

Power Cord

Do not subject the power cord to excessive force. Cables and cords

are more susceptible to damage when bent or twisted.

Make sure the main switch @ is set to " \ " (OFF) before connecting

the power cord. (Fig. 15)

1. Connect the lamp cord plug @ securely to the connector ² on the rear

of the microscope body. (Fig. 15)

Do not connect anything other than the lamp cord plug @ to the

connector ². Doing so will cause equipment failure.

Always use the power cord provided by Olympus. If no power cord

is provided, please select the proper power cord by referring to the

‡

section "PROPER SELECTION OF THE POWER SUPPLY CORD" at

the end of this instruction manual.

2. Be sure to set the input voltage selector ³ to the required voltage. Input

voltage is factory-set to 110 – 120 V or 230 – 240 V.

3. Insert the power cord plug | securely into the connector ƒ. (Fig. 15)

4. Insert the power cord plug † securely into the wall outlet ‡. (Fig. 16)

Connect the power cord correctly and ensure that the ground termi-

nal of the power supply and that of the wall outlet are properly con-

nected. If the equipment is not grounded, Olympus can no longer

warrant the electrical safety and performance of the equipment.

CK30/CK40

(Figs. 15 & 16)