Olympus CK40M FRAME 수리 매뉴얼 - 페이지 5

{카테고리_이름} Olympus CK40M FRAME에 대한 수리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus CK40M FRAME 38 페이지. Compact inverted metallurgical microscope

CK40M

• When CK40-MVR (mechanical stage) is mounted on the right side (seen from the

operation knob side) of the plane stage, CK40M-MS (stage mirror) cannot be mounted

on there.

• When it is combined with CK40M-CP (stage plate), the observation range depends on

the objective. In some cases, the CK40M-CP is pushed up by changing to a high

magnification objective. (High magnification)

Combination with MDPlan80X:

The narrow part in the clip hole (shape: tear drop) of the stage plate cannot be

observed. The part around φ15 mm in the clip hole of CK40M-CP is pushed up

by changing to the objective.

Combination with MDPlan50X:

When the clip hole (shape: tear drop) of the stage plate is positioned in the non-

breadthwise direction (when it is not combined with CK40M-MVR), the part

around φ15 mm in the clip hole of CK40M-CP is pushed up in some cases by

changing to the objective.

• When DP10 is combined with NFK2.5X, density may be uneven on one side of the field.

This is a restriction of DP10.

• When it is combined with a TV camera including a photo element, a spot flare may

occur on the TV monitor at a high-reflection mirror when the objective 50X or higher +

NFK2.5X or 3X are used.

(This is caused by surface reflection of the CCD surface and the NFK lens.)

• When it is combined with a TV camera including a 2/3 inch or larger photo element and

NFK1.67X, vigentting will occur at the four corners of the screen.

• When it is combined with CK40M-PO, the polarizer can be rotated more than 90° from

the crossed Nicol (total extinction) position to the index side, but less than 90° in the

opposite direction.

(3)

This model can be combined with the following objectives:

MDAch10X

MDAch20X

MDAch50X

MDPlan5X

MDPlan10X

MDPlan20X

MDPlan40X

MDPlan50X

MDPlan80X

This model cannot be combined with the following objectives: LB (long barrel) objectives

other than the above, SB (short barrel) objectives, and UIS objectives.

A. OUTLINE OF PRODUCT

A-2