Olympus SZX7 사용 설명서 - 페이지 20

{카테고리_이름} Olympus SZX7에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus SZX7 32 페이지. Stereomicroscope system
Olympus SZX7에 대해서도 마찬가지입니다: 사용 설명서 (32 페이지)

8-2 Detailed Assembly Procedures

Fig. 13

Fig. 14

Fig. 15

Installing the Microscope Body

1. Loosen the body clamping knob @ and insert the microscope body ²

gently into the mounting hole of the standard stand.

}The body clamping knob @ can be attached to any of the accessory

mounting screw holes ³ around the mounting hole. It may be necessary

to change the knob position when a module such as an illumination

system is mounted.

2. Position the microscope body so that it faces frontward and tighten the

body clamping knob @.

}If it is required to position the zoom adjustment knob near the focus

adjustment knob |, position the microscope body in the opposite

orientation.

Mounting the Objective

Attach the objective ² to the objective mount thread @ by turning the

objective in the direction of the arrow.

}The SZ2-ET auxiliary sleeve is required when the 0.5X objective is used.

Mounting the Observation Tube

1. Using the Allen screwdriver, fully loosen the observation tube clamping

screw @.

2. Aligning the positioning groove ² of the observation tube with the posi-

tioning pin ³ of the microscope body, fit the dovetail | at the bottom of

the observation tube into the dovetail mount ƒ of the microscope body.

3. Tighten the observation tube clamping screw @ firmly using the Allen

screwdriver.

# If you always perform observation from the side of the focus adjust-

ment knobs, the microscope body can be installed in the opposite

orientation to that shown in the figure (at the 180° rotated position).

(Fig. 13)

(Fig. 14)

(Fig. 15)