AccuLine 40-6540 서비스 매뉴얼 - 페이지 4

{카테고리_이름} AccuLine 40-6540에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuLine 40-6540 13 페이지. Automatic rotating laser

2.1.1 Rotating Head/Prism Disassembly (AP1793/AP1795)

Using a Phillips screw driver, remove 2 screws (13-1) from 13-5 and gently lift off 13-2 and 13-3.

Using a Phillips screw driver, remove 4 screws/washers (13-9, 13-10) from 13-26 and gently lift off 13-11

2.1.2 Shaft Coupling Module Disassembly (AP1797)

Using a 1.5 mm Allen Wrench, loosen set screw

located on the top side of the gimbal assembly

pictured to the right.

Using a flat screw driver, remove 2 inner screws that

connect the gimbal assembly to the laser/motor

assembly (13-14). Reference the picture to the

right.

Due to the nature of the laser/motor assembly (13-14)

and the fact that the x, y, and z level indicators are

factor calibrated, no further disassembly instructions

are provided.



If any component of this assembly is suspect,

the entire assembly should be replaced.

2.1.3 X Direction Leveling Module Disassembly (AP1800)

Remove X direction leveling module (13-15) by removing the 3 cross head screws located on the bottom side of

13-16 Bottom Plate.



Due to the mechanical nature of this assembly, some of the components can become worn and may require

period lubrication and/or readjustment (i.e. gear, shaft, motor, etc.)



In the event that the unit is damaged due to being dropped, all bent or damaged components should be replaced

as this assembly is integral to the self leveling of the device.

2.1.4 Y Direction Leveling Module Disassembly (AP1806)

Remove Y direction leveling module (13-25) by removing the 3 cross head screws located on the bottom side of

13-16 Bottom Plate.



Due to the mechanical nature of this assembly, some of the components can become worn and may require

period lubrication and/or readjustment (i.e. gear, shaft, motor, etc.)



In the event that the unit is damaged due to being dropped, all bent or damaged components should be replaced

as this assembly is integral to the self leveling of the device.

2.1.5 Alarm Board Removal/Replacement (AP1805)

Using a Phillips screw driver, remove 2 screws/washers (13-23, 13-24) from 13-16 and gently remove circuit board

from assembly.

Prepared By: Tim Wojo

Revision - Date: 0 – 20080430

40-6540 Service Manual

Gimbal Assembly

Page 4 of 13