Olympus BH-NRE 매뉴얼 - 페이지 8

{카테고리_이름} Olympus BH-NRE에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BH-NRE 17 페이지. Modular revolving nosepiece

페이지 인쇄

Figure 13 – Loosen the slotted lock ring

Once the slotted lock ring has been loosened, remove

the screwdriver handle from the bores in the revolving

turret and the stationary base (which is locking the

revolving turret to the stationary base) to get it out of

the way. Unscrew and remove the slotted lock ring

from the pivot-adjustment screw (see

Figure 14 – Remove the slotted lock ring

Remove the Pivot-Adjustment Screw

With the slotted lock ring removed, use a suitable

slotted screwdriver to unscrew and remove the pivot-

adjustment screw from the center bore of the

stationary base (see

Figure

ball in the center bore of the stationary base, beneath

the pivot-adjustment screw. Do not allow this bearing

ball to fall out or it may become lost.

Figure 15 – Remove the pivot-adjustment screw

Complete Teardown, Cleaning, and Reassembly of the Olympus BH-NRE Modular Revolving Nosepiece

Figure

14).

15). There is a ¼" bearing

Remove the Center-Pivot Bearing Ball

Use a tweezers to remove the ¼" bearing ball from the

center bore in the stationary base (see

Figure 16 – Remove the center-pivot bearing ball

Remove the Threaded Retaining Ring

The stationary base is held inside the recess of the

revolving turret by the threaded retaining ring (see

Figure

17).

Figure 17 – Components of the turret assembly

Place the turret assembly into a suitable work vise and

use a heat gun to thoroughly heat the turret assembly,

to soften the internal grease. Then use a center punch

or nailset tool to loosen the threaded retaining ring by

placing the tip of the tool into one of the four tooling

holes in the threaded retaining ring (see

driving the threaded retaining ring counter-clockwise by

carefully tapping the tool with a small hammer or mallet

(see

Figure

18). Be careful and do not accidentally put

the center punch or nailset tool into one of the four

detent notches in the revolving turret (instead of into

one of the four tooling holes in the threaded retaining

ring), or the revolving turret will be irreparably

damaged when the punch is struck by the mallet.

Figure

16).

Figure

17) and

Page 8 of 17

Revision 3