Olympus U-AFA2M-VIS 사용 설명서 - 페이지 20
{카테고리_이름} Olympus U-AFA2M-VIS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus U-AFA2M-VIS 24 페이지. Active autofocusing unit
페이지 인쇄
TROUBLESHOOTING GUIDE
Under certain conditions, performance of the unit may be adversely affected by factors other than defects. If problems
occur, please review the following list and take remedial action as needed. If you cannot solve the problem after checking
the entire list, please contact Olympus for assistance.
Problem
The unit cannot be turned ON.
The focusing module is not initialized
after power ON.
The control from the dedicated soft-
ware is not available.
AF is not successful in DIC observa-
tion.
AF is not successful.
An error occurs immediately after
the start of AF.
An error occurs after the focusing module starts to move after the start of AF.
The error occurs with all ob-
jectives.
16
Cause
A wrong cable is connected.
The DIP switches are set improperly.
The AF control board is connected im-
properly.
The microscope is being initialized.
The DIP switches on the BX-UCB are
set improperly.
A wrong RS-232C cable is connected. Connect a straight cable with D-SUB
There is wire connection or contact fail-
ure in the connection cables.
The prism movement knob on the DIC
slider is set improperly.
No limits are set for the focusing mod-
ule.
The AF zone is not set.
The termination connector is unplugged. Plug it in.
A motorized unit is operating.
The AF laser spot is
captured in the
photomicrograph.
The limits are set improperly.
The AF zone is set improperly.
The DIP switches are set improperly.
The retardation in DIC observation is
set to a position with low return light.
The objective on the revolving nose-
piece is different from that handled with
the control software.
Remedy
Connect the appropriate cable.
Set them properly.
Check its connection.
Wait until the initialization completes
before launching the software.
Set them properly.
9-pin female-female connectors.
Check the connections of the cables.
Turn the prism movement knob and
retry AF operation.
Set the focusing limits.
Set the AF zone.
Wait until the motorized unit completes
operation.
Use a CCD camera incorporating an
IR cut filter.
Re-set the focusing module limits.
Re-set the AF zone.
Set them properly.
Execute AF with a different retardation
position, and then re-adjust it.
Check if the objective on the revolving
nosepiece matches that handled with
the software.
Page
BX-UCB
Instructions
9
10
Software
Instructions
BX-UCB
Instructions
BX-UCB
Instructions
7
12
Software
Instructions
Software
Instructions
6
---
2
Software
Instructions
Software
Instructions
9
12
Software
Instructions