Axler CS-CF-30LW 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Axler CS-CF-30LW에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axler CS-CF-30LW 6 페이지.

T H A N K Y O U F O R C H O O S I N G A X L E R .
The Axler CS-CF-30LW Camera Slider is a lightweight and portable
solution for capturing tracking shots and push-ins that can add
artistic and cinematic elements to your video productions. With
19 mm carbon fiber rails that support up to 18 pounds, this slider
is capable of accommodating DSLR cameras, camcorders, and
mirrorless cameras. Six wheels assure quiet and smooth tracking
along the rails for fluid camera motion that a microphone won't pick
up. A brake lever is conveniently located on the side of the base.
The aluminum camera base employs a 1/4-inch mounting stud for a
video head or ball head, and it includes a 3/8-inch adapter bushing if
a larger stud is needed. 1/4- and 3/8-inch mounting sockets on the
bottom mounting plate and on the end pieces will accommodate
lights, microphones, and other accessories for your rig. Adjustable
outrigger feet can be fine-tuned for stability on uneven surfaces.
U S I N G T H E S L I D E R O N A TA B L E T O P
1. Loosen the leg adjustment knobs, and move each leg to the desired
height. Then tighten the knobs until the legs
are secure.
2. Fine-tune the height of each foot by
twisting it up or down until the slider is
stable and doesn't wobble.
3. Lock the feet by tightening the nuts until
they are flush against the legs.
M O U N T I N G T H E C S - C F - 3 0 L W
The CS-CF-30LW can be mounted on a single
tripod. For added stability, the slider can be
supported by two tripods or light stands.
Note: To avoid wobbling and camera shake,
use sand bags or other weights to stabilize
your tripods or light stands.
M O U N T I N G O N O N E T R I P O D
1. Center the camera base on the slider, and
lock it down with the brake.
2. Align the appropriate mounting hole on
the bottom of the camera base with the
mounting post of the tripod, and screw the
tripod in.
Tip: It may be easier to turn the slider
upside down to screw in the tripod.